K0FTT Automobiles

My position About ☰

reset

SP2PA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2PA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765983980	73 Count	198 Count	50 Count
1765982179	72 Count	198 Count	50 Count
1765980378	71 Count	198 Count	50 Count
1765978592	70 Count	198 Count	50 Count
1765976791	69 Count	198 Count	50 Count
1765974990	68 Count	198 Count	50 Count
1765973188	67 Count	198 Count	50 Count
1765971387	65 Count	195 Count	49 Count
1765969584	54 Count	185 Count	39 Count
1765967783	53 Count	185 Count	39 Count
1765965982	52 Count	185 Count	39 Count
1765964181	51 Count	185 Count	39 Count
1765962380	49 Count	184 Count	38 Count
1765960579	48 Count	184 Count	38 Count
1765958778	47 Count	184 Count	38 Count
1765956986	45 Count	178 Count	37 Count
1765955185	18 Count	120 Count	11 Count
1765953384	15 Count	89 Count	9 Count
1765951583	14 Count	87 Count	9 Count
1765949782	11 Count	47 Count	7 Count
1765947981	9 Count	41 Count	6 Count
1765946180	6 Count	32 Count	4 Count
1765944379	4 Count	27 Count	3 Count
1765942578	1 Count	15 Count	1 Count
1765940777	649 Count	1007 Count	127 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)