K0FTT Automobiles

My position About ☰

reset

SP4HMU-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP4HMU-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1760379955	117 Count	885 Count	14 Count
1760378155	116 Count	872 Count	14 Count
1760376354	115 Count	860 Count	14 Count
1760374554	114 Count	847 Count	14 Count
1760372753	113 Count	841 Count	14 Count
1760370952	111 Count	838 Count	13 Count
1760369152	110 Count	836 Count	13 Count
1760367351	108 Count	833 Count	12 Count
1760365550	107 Count	831 Count	12 Count
1760363750	106 Count	829 Count	12 Count
1760361949	105 Count	827 Count	12 Count
1760360148	104 Count	824 Count	12 Count
1760358355	102 Count	821 Count	11 Count
1760356554	101 Count	819 Count	11 Count
1760354753	100 Count	817 Count	11 Count
1760352953	99 Count	815 Count	11 Count
1760351152	97 Count	810 Count	10 Count
1760349351	95 Count	807 Count	9 Count
1760347551	94 Count	798 Count	9 Count
1760345750	93 Count	789 Count	9 Count
1760343949	92 Count	779 Count	9 Count
1760342149	91 Count	765 Count	9 Count
1760340348	90 Count	754 Count	9 Count
1760338548	89 Count	741 Count	9 Count
1760336754	88 Count	728 Count	9 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)