K0FTT Automobiles

My position About ☰

reset

LW2DHT-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LW2DHT-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1766093183	624 Count	453 Count	418 Count
1766091379	621 Count	451 Count	416 Count
1766089576	618 Count	449 Count	414 Count
1766087773	614 Count	446 Count	411 Count
1766085970	611 Count	444 Count	409 Count
1766084166	607 Count	441 Count	406 Count
1766082363	603 Count	438 Count	403 Count
1766080560	600 Count	436 Count	401 Count
1766078757	596 Count	433 Count	398 Count
1766076951	593 Count	431 Count	396 Count
1766075148	589 Count	428 Count	393 Count
1766073383	585 Count	425 Count	390 Count
1766071580	582 Count	423 Count	388 Count
1766069777	579 Count	421 Count	386 Count
1766067973	576 Count	419 Count	384 Count
1766066170	573 Count	417 Count	382 Count
1766064367	570 Count	415 Count	380 Count
1766062564	567 Count	413 Count	378 Count
1766060760	563 Count	410 Count	375 Count
1766058957	559 Count	407 Count	372 Count
1766057154	555 Count	404 Count	369 Count
1766055351	552 Count	402 Count	367 Count
1766053547	549 Count	400 Count	365 Count
1766051772	546 Count	398 Count	363 Count
1766049966	543 Count	396 Count	361 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)