K0FTT Automobiles

My position About ☰

reset

EA4GMY-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4GMY-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1760029873	204 Count	261 Count	163 Count
1760028066	200 Count	258 Count	161 Count
1760027163	198 Count	256 Count	160 Count
1760026261	196 Count	253 Count	159 Count
1760025356	194 Count	251 Count	158 Count
1760024453	192 Count	249 Count	157 Count
1760023550	190 Count	247 Count	156 Count
1760022646	188 Count	244 Count	155 Count
1760021743	185 Count	241 Count	153 Count
1760020840	183 Count	239 Count	152 Count
1760019936	181 Count	237 Count	151 Count
1760019033	179 Count	234 Count	150 Count
1760018130	177 Count	232 Count	149 Count
1760017226	175 Count	230 Count	148 Count
1760016323	170 Count	225 Count	144 Count
1760015420	155 Count	206 Count	130 Count
1760013690	110 Count	160 Count	91 Count
1760012787	96 Count	142 Count	78 Count
1760011883	88 Count	130 Count	71 Count
1760010980	81 Count	120 Count	65 Count
1760010077	79 Count	115 Count	64 Count
1760009173	75 Count	108 Count	61 Count
1760008270	72 Count	102 Count	59 Count
1760005560	27 Count	45 Count	17 Count
1760004657	25 Count	42 Count	16 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)