K0FTT Automobiles

My position About ☰

reset

SQ9KFZ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9KFZ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1758054858	11 Count	60 Count	9 Count
1758053957	7 Count	43 Count	6 Count
1758053056	3 Count	20 Count	3 Count
1758052156	125 Count	1005 Count	98 Count
1758051255	121 Count	980 Count	95 Count
1758050354	117 Count	965 Count	92 Count
1758049454	113 Count	938 Count	89 Count
1758048553	109 Count	915 Count	86 Count
1758047652	105 Count	891 Count	83 Count
1758046752	101 Count	849 Count	80 Count
1758045851	97 Count	794 Count	77 Count
1758044950	93 Count	756 Count	74 Count
1758044050	89 Count	716 Count	71 Count
1758043149	85 Count	682 Count	68 Count
1758042249	82 Count	642 Count	66 Count
1758041348	78 Count	619 Count	63 Count
1758040447	74 Count	591 Count	60 Count
1758039546	59 Count	538 Count	46 Count
1758038646	55 Count	504 Count	43 Count
1758037745	51 Count	473 Count	40 Count
1758036845	47 Count	435 Count	37 Count
1758035944	43 Count	399 Count	34 Count
1758035043	39 Count	358 Count	31 Count
1758034143	32 Count	311 Count	25 Count
1758033242	27 Count	263 Count	21 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)