K0FTT Automobiles

My position About ☰

reset

IT9IRS-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IRS-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1768204095	174 Count	345 Count
1768202292	173 Count	344 Count
1768200488	172 Count	342 Count
1768196881	170 Count	340 Count
1768195078	169 Count	339 Count
1768193274	168 Count	337 Count
1768189667	166 Count	332 Count
1768187863	165 Count	331 Count
1768186099	160 Count	328 Count
1768184296	159 Count	327 Count
1768182492	158 Count	325 Count
1768180689	157 Count	318 Count
1768178885	156 Count	315 Count
1768177081	155 Count	314 Count
1768175278	154 Count	308 Count
1768173475	153 Count	301 Count
1768171671	152 Count	298 Count
1768169867	151 Count	295 Count
1768168064	150 Count	294 Count
1768166260	149 Count	292 Count
1768164497	144 Count	286 Count
1768162693	143 Count	273 Count
1768160890	142 Count	266 Count
1768159086	141 Count	259 Count
1768157282	140 Count	251 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)