K0FTT Automobiles

My position About ☰

reset

IT9EWK-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9EWK-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1758659490	35 Count	243 Count
1758657687	34 Count	234 Count
1758655883	33 Count	224 Count
1758654079	32 Count	216 Count
1758652315	27 Count	208 Count
1758650511	26 Count	198 Count
1758648707	25 Count	191 Count
1758646904	24 Count	183 Count
1758645100	23 Count	173 Count
1758643296	22 Count	165 Count
1758641492	21 Count	154 Count
1758639688	20 Count	146 Count
1758637885	19 Count	133 Count
1758636081	18 Count	125 Count
1758634277	17 Count	117 Count
1758632473	16 Count	108 Count
1758631705	11 Count	105 Count
1758629901	10 Count	98 Count
1758628098	9 Count	91 Count
1758626294	8 Count	83 Count
1758603321	129 Count	913 Count
1758601517	128 Count	901 Count
1758599713	127 Count	889 Count
1758597910	126 Count	877 Count
1758596106	125 Count	865 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)