K0FTT Automobiles

My position About ☰

reset

SQ9IDT-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9IDT-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1768202764	68 Count	393 Count	58 Count
1768200963	45 Count	240 Count	38 Count
1768199166	22 Count	116 Count	20 Count
1768195561	240 Count	949 Count	207 Count
1768188359	147 Count	525 Count	125 Count
1768186558	125 Count	446 Count	106 Count
1768184757	107 Count	367 Count	91 Count
1768182957	85 Count	292 Count	72 Count
1768181156	64 Count	218 Count	55 Count
1768179355	41 Count	133 Count	35 Count
1768177555	21 Count	60 Count	18 Count
1768175754	264 Count	1064 Count	224 Count
1768173954	244 Count	994 Count	207 Count
1768172153	221 Count	916 Count	187 Count
1768170352	201 Count	822 Count	169 Count
1768168564	175 Count	748 Count	150 Count
1768166763	152 Count	666 Count	130 Count
1768164963	129 Count	575 Count	111 Count
1768163162	105 Count	472 Count	90 Count
1768161360	96 Count	397 Count	84 Count
1768159560	73 Count	308 Count	64 Count
1768157759	49 Count	201 Count	44 Count
1768155958	26 Count	112 Count	24 Count
1768154158	236 Count	1006 Count	204 Count
1768152357	202 Count	885 Count	174 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)