K0FTT Automobiles

My position About ☰

reset

OK1OBR-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1OBR-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1768183401	19 Count	451 Count
1768181598	18 Count	421 Count
1768179837	17 Count	366 Count
1768178033	16 Count	335 Count
1768176229	15 Count	328 Count
1768174425	14 Count	317 Count
1768172622	13 Count	288 Count
1768170818	12 Count	259 Count
1768169015	11 Count	242 Count
1768167211	10 Count	223 Count
1768165408	9 Count	204 Count
1768163605	8 Count	178 Count
1768161801	7 Count	152 Count
1768159998	6 Count	123 Count
1768158235	4 Count	109 Count
1768156432	3 Count	91 Count
1768154627	2 Count	71 Count
1768152824	1 Count	54 Count
1768151020	0 Count	25 Count
1768149217	67 Count	1027 Count
1768147414	66 Count	1000 Count
1768145610	65 Count	970 Count
1768143807	64 Count	944 Count
1768142004	63 Count	895 Count
1768140200	62 Count	858 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)