K0FTT Automobiles

My position About ☰

reset

SP1GDK-6 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP1GDK-6. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1761869021	231 Count	171 Count
1761868415	230 Count	170 Count
1761867809	229 Count	170 Count
1761867203	228 Count	169 Count
1761866597	227 Count	168 Count
1761865990	226 Count	168 Count
1761865383	225 Count	168 Count
1761864777	224 Count	167 Count
1761864170	223 Count	166 Count
1761863563	222 Count	166 Count
1761862957	221 Count	165 Count
1761862351	220 Count	164 Count
1761861743	219 Count	164 Count
1761861137	218 Count	163 Count
1761860530	217 Count	163 Count
1761859923	216 Count	163 Count
1761859317	215 Count	163 Count
1761858711	214 Count	162 Count
1761858105	213 Count	162 Count
1761857499	212 Count	162 Count
1761856892	211 Count	162 Count
1761856286	210 Count	162 Count
1761855680	209 Count	161 Count
1761855074	208 Count	160 Count
1761854467	207 Count	160 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)