K0FTT Automobiles

My position About ☰

reset

SP3LSN-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3LSN-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765983129	752 Count	531 Count	74 Count
1765981328	751 Count	531 Count	74 Count
1765979528	750 Count	531 Count	74 Count
1765977727	749 Count	531 Count	74 Count
1765975926	748 Count	531 Count	74 Count
1765974126	747 Count	531 Count	74 Count
1765972325	746 Count	531 Count	74 Count
1765970525	745 Count	531 Count	74 Count
1765968724	744 Count	531 Count	74 Count
1765966923	743 Count	531 Count	74 Count
1765965123	742 Count	531 Count	74 Count
1765963329	741 Count	531 Count	74 Count
1765961528	740 Count	531 Count	74 Count
1765959728	739 Count	531 Count	74 Count
1765957927	738 Count	531 Count	74 Count
1765956127	737 Count	531 Count	74 Count
1765954326	736 Count	531 Count	74 Count
1765952525	735 Count	531 Count	74 Count
1765950725	733 Count	526 Count	73 Count
1765948924	731 Count	523 Count	72 Count
1765947123	730 Count	522 Count	72 Count
1765945323	729 Count	521 Count	72 Count
1765943522	728 Count	521 Count	72 Count
1765941728	727 Count	518 Count	72 Count
1765939927	726 Count	517 Count	72 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)