K0FTT Automobiles

My position About ☰

reset

EA4ENG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4ENG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1757249991	504 Count	723 Count	208 Count
1757249088	501 Count	721 Count	206 Count
1757248184	497 Count	718 Count	203 Count
1757247280	494 Count	716 Count	201 Count
1757246471	492 Count	715 Count	200 Count
1757245568	489 Count	713 Count	198 Count
1757244664	486 Count	711 Count	196 Count
1757243760	483 Count	709 Count	194 Count
1757242856	480 Count	707 Count	192 Count
1757241952	476 Count	704 Count	189 Count
1757241048	473 Count	702 Count	187 Count
1757240145	469 Count	699 Count	184 Count
1757239241	466 Count	697 Count	182 Count
1757238337	462 Count	694 Count	179 Count
1757237433	459 Count	692 Count	177 Count
1757236529	455 Count	689 Count	174 Count
1757235625	452 Count	687 Count	172 Count
1757234717	449 Count	685 Count	170 Count
1757233813	446 Count	683 Count	168 Count
1757232909	444 Count	682 Count	167 Count
1757232006	442 Count	681 Count	166 Count
1757231102	440 Count	680 Count	165 Count
1757230198	438 Count	679 Count	164 Count
1757229294	435 Count	677 Count	162 Count
1757228390	431 Count	674 Count	159 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)