K0FTT Automobiles

My position About ☰

reset

SQ4HSE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4HSE-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1765985312	44 Count	300 Count	30 Count
1765981711	41 Count	287 Count	28 Count
1765978110	38 Count	273 Count	26 Count
1765974510	35 Count	260 Count	24 Count
1765970909	32 Count	247 Count	22 Count
1765967308	29 Count	225 Count	20 Count
1765963707	26 Count	202 Count	18 Count
1765960106	23 Count	178 Count	16 Count
1765956506	20 Count	156 Count	14 Count
1765952905	17 Count	135 Count	12 Count
1765949304	14 Count	113 Count	10 Count
1765945703	11 Count	92 Count	8 Count
1765942103	8 Count	72 Count	6 Count
1765938503	5 Count	48 Count	4 Count
1765934901	2 Count	25 Count	2 Count
1765931300	141 Count	1003 Count	97 Count
1765927699	138 Count	978 Count	95 Count
1765920498	132 Count	931 Count	91 Count
1765913297	126 Count	895 Count	87 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)