K0FTT Automobiles

My position About ☰

reset

SP5MSV-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5MSV-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1764273827	73 Count	130 Count	14 Count
1764272025	72 Count	130 Count	14 Count
1764270228	71 Count	128 Count	14 Count
1764268424	70 Count	125 Count	14 Count
1764266623	69 Count	122 Count	14 Count
1764264822	68 Count	122 Count	14 Count
1764263030	67 Count	121 Count	14 Count
1764261229	66 Count	121 Count	14 Count
1764259428	65 Count	121 Count	14 Count
1764257629	64 Count	121 Count	14 Count
1764255827	63 Count	120 Count	14 Count
1764254026	62 Count	120 Count	14 Count
1764252226	60 Count	115 Count	13 Count
1764250425	59 Count	113 Count	13 Count
1764248624	57 Count	111 Count	12 Count
1764246824	56 Count	109 Count	12 Count
1764245023	55 Count	108 Count	12 Count
1764243222	54 Count	106 Count	12 Count
1764241430	53 Count	101 Count	12 Count
1764239629	51 Count	98 Count	11 Count
1764237828	50 Count	94 Count	11 Count
1764236027	49 Count	93 Count	11 Count
1764234227	48 Count	90 Count	11 Count
1764232426	45 Count	85 Count	9 Count
1764230625	44 Count	83 Count	9 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)