K0FTT Automobiles

My position About ☰

reset

IW9GTR-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IW9GTR-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1758644428	87 Count	228 Count	54 Count
1758643374	82 Count	217 Count	51 Count
1758642165	77 Count	206 Count	48 Count
1758640956	70 Count	192 Count	43 Count
1758639748	65 Count	181 Count	40 Count
1758638539	61 Count	171 Count	38 Count
1758637330	54 Count	159 Count	33 Count
1758636120	49 Count	147 Count	30 Count
1758634912	45 Count	134 Count	28 Count
1758633703	38 Count	120 Count	23 Count
1758632494	33 Count	111 Count	20 Count
1758631285	29 Count	100 Count	18 Count
1758630077	23 Count	85 Count	14 Count
1758628867	19 Count	61 Count	12 Count
1758627659	15 Count	45 Count	10 Count
1758626450	8 Count	28 Count	5 Count
1758625241	3 Count	14 Count	2 Count
1758624032	389 Count	1004 Count	240 Count
1758622823	382 Count	989 Count	235 Count
1758621774	377 Count	978 Count	232 Count
1758620565	372 Count	968 Count	229 Count
1758619356	365 Count	949 Count	224 Count
1758618147	360 Count	931 Count	221 Count
1758616938	356 Count	918 Count	219 Count
1758615729	350 Count	903 Count	215 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)