K0FTT Automobiles

My position About ☰

reset

OK1LOL-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1LOL-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1754282397	75 Count	253 Count
1754280594	74 Count	241 Count
1754278791	73 Count	228 Count
1754276988	72 Count	216 Count
1754275220	71 Count	203 Count
1754273417	70 Count	191 Count
1754271614	69 Count	179 Count
1754269811	68 Count	167 Count
1754268008	66 Count	155 Count
1754266204	64 Count	149 Count
1754264401	63 Count	134 Count
1754262598	61 Count	120 Count
1754260794	59 Count	111 Count
1754258991	58 Count	99 Count
1754257188	56 Count	83 Count
1754255385	55 Count	69 Count
1754255336	54 Count	69 Count
1754255273	53 Count	68 Count
1754255210	52 Count	68 Count
1754255147	51 Count	67 Count
1754255084	50 Count	67 Count
1754255021	49 Count	67 Count
1754254958	48 Count	67 Count
1754254895	47 Count	66 Count
1754254832	46 Count	65 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)