K0FTT Automobiles

My position About ☰

reset

IT9IRS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IRS-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1768209910	24 Count	269 Count
1768208106	23 Count	249 Count
1768206303	22 Count	229 Count
1768205281	17 Count	229 Count
1768203477	16 Count	213 Count
1768201674	15 Count	196 Count
1768199870	14 Count	181 Count
1768198067	13 Count	167 Count
1768196263	12 Count	153 Count
1768194460	11 Count	139 Count
1768192696	6 Count	109 Count
1768190899	5 Count	92 Count
1768189089	4 Count	78 Count
1768187285	3 Count	65 Count
1768185482	2 Count	52 Count
1768183678	1 Count	36 Count
1768181875	0 Count	19 Count
1768180071	71 Count	1003 Count
1768178268	70 Count	989 Count
1768176464	69 Count	975 Count
1768174660	68 Count	959 Count
1768172857	67 Count	946 Count
1768171093	62 Count	932 Count
1768169296	61 Count	889 Count
1768167486	60 Count	856 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)