K0FTT Automobiles

My position About ☰

reset

SQ2SIX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2SIX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1758048139	56 Count	879 Count	56 Count
1758047539	56 Count	878 Count	56 Count
1758046939	56 Count	874 Count	56 Count
1758046339	56 Count	871 Count	56 Count
1758045739	56 Count	870 Count	56 Count
1758045139	56 Count	866 Count	56 Count
1758044539	56 Count	863 Count	56 Count
1758043939	56 Count	862 Count	56 Count
1758043339	56 Count	858 Count	56 Count
1758042739	56 Count	855 Count	56 Count
1758042139	56 Count	853 Count	56 Count
1758041539	56 Count	849 Count	56 Count
1758040939	56 Count	846 Count	56 Count
1758040339	56 Count	845 Count	56 Count
1758039739	56 Count	840 Count	56 Count
1758039138	56 Count	837 Count	56 Count
1758038538	56 Count	836 Count	56 Count
1758037936	56 Count	831 Count	56 Count
1758037336	56 Count	827 Count	56 Count
1758036736	56 Count	826 Count	56 Count
1758036135	56 Count	822 Count	56 Count
1758035535	56 Count	819 Count	56 Count
1758034935	56 Count	818 Count	56 Count
1758034335	56 Count	808 Count	56 Count
1758033735	56 Count	802 Count	56 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)