K0FTT Automobiles

My position About ☰

reset

OK1LOL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1LOL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1765971535	175 Count	1004 Count
1765969732	174 Count	998 Count
1765967929	173 Count	991 Count
1765966163	172 Count	986 Count
1765964360	171 Count	980 Count
1765962557	170 Count	974 Count
1765960754	169 Count	968 Count
1765958951	168 Count	962 Count
1765957148	167 Count	957 Count
1765955345	166 Count	950 Count
1765953542	165 Count	944 Count
1765951739	164 Count	937 Count
1765949935	163 Count	931 Count
1765948132	162 Count	925 Count
1765946329	161 Count	919 Count
1765944561	160 Count	913 Count
1765942758	159 Count	907 Count
1765940957	158 Count	900 Count
1765939152	157 Count	893 Count
1765937349	156 Count	885 Count
1765935546	155 Count	878 Count
1765933743	154 Count	870 Count
1765931940	153 Count	863 Count
1765930137	150 Count	855 Count
1765928334	149 Count	848 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)