K0FTT Automobiles

My position About ☰

reset

SP9KPS-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9KPS-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1757550349	87 Count	1061 Count	74 Count
1757548548	83 Count	982 Count	71 Count
1757546747	79 Count	892 Count	68 Count
1757544946	72 Count	801 Count	62 Count
1757543145	63 Count	715 Count	54 Count
1757541345	59 Count	605 Count	51 Count
1757539544	55 Count	496 Count	48 Count
1757537743	50 Count	407 Count	44 Count
1757535942	46 Count	319 Count	41 Count
1757534141	26 Count	201 Count	23 Count
1757532340	5 Count	69 Count	3 Count
1757479910	4 Count	69 Count	3 Count
1757478109	0 Count	0 Count	0 Count
1757476317	64 Count	962 Count	43 Count
1757474516	61 Count	895 Count	41 Count
1757472715	55 Count	826 Count	37 Count
1757470914	51 Count	772 Count	34 Count
1757469114	47 Count	709 Count	31 Count
1757467313	43 Count	654 Count	29 Count
1757465512	40 Count	595 Count	27 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)