K0FTT Automobiles

My position About ☰

reset

OK1CDJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1CDJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1761864785	113 Count	96 Count
1761861182	112 Count	96 Count
1761857579	111 Count	96 Count
1761853976	110 Count	96 Count
1761850373	109 Count	96 Count
1761846770	108 Count	94 Count
1761843184	107 Count	89 Count
1761839581	106 Count	89 Count
1761835978	105 Count	89 Count
1761832375	104 Count	89 Count
1761828772	103 Count	89 Count
1761825169	102 Count	82 Count
1761821583	101 Count	82 Count
1761817980	100 Count	82 Count
1761814377	99 Count	80 Count
1761810774	98 Count	80 Count
1761807171	97 Count	78 Count
1761803568	96 Count	73 Count
1761799983	95 Count	73 Count
1761796380	94 Count	67 Count
1761792777	93 Count	67 Count
1761789173	92 Count	67 Count
1761785570	91 Count	67 Count
1761781967	90 Count	67 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)