K0FTT Automobiles

My position About ☰

reset

SP9WKL-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9WKL-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1761972201	8 Count	195 Count
1761970400	7 Count	171 Count
1761968607	6 Count	146 Count
1761966806	5 Count	129 Count
1761965005	4 Count	107 Count
1761963205	3 Count	85 Count
1761961404	2 Count	78 Count
1761959603	1 Count	58 Count
1761957803	0 Count	26 Count
1761956002	46 Count	1021 Count
1761954201	45 Count	997 Count
1761952401	44 Count	978 Count
1761950600	43 Count	967 Count
1761948799	42 Count	948 Count
1761947007	41 Count	943 Count
1761945206	40 Count	933 Count
1761943405	39 Count	917 Count
1761941605	38 Count	902 Count
1761939804	37 Count	887 Count
1761938003	36 Count	849 Count
1761936203	35 Count	821 Count
1761934402	34 Count	783 Count
1761932601	33 Count	761 Count
1761930801	32 Count	732 Count
1761929000	31 Count	699 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)