K0FTT Automobiles

My position About ☰

reset

SQ4VK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4VK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1766042881	73 Count	3 Count	0 Count
1766041980	66 Count	2 Count	0 Count
1766041079	58 Count	2 Count	0 Count
1766040179	52 Count	2 Count	0 Count
1766039278	46 Count	1 Count	0 Count
1766038377	39 Count	1 Count	0 Count
1766037476	33 Count	1 Count	0 Count
1766036576	26 Count	0 Count	0 Count
1766035675	20 Count	0 Count	0 Count
1766034774	14 Count	0 Count	0 Count
1766033874	7 Count	0 Count	0 Count
1766032973	1008 Count	81 Count	60 Count
1766032072	990 Count	69 Count	48 Count
1766031172	982 Count	68 Count	47 Count
1766030271	977 Count	68 Count	47 Count
1766029370	969 Count	68 Count	47 Count
1766028469	963 Count	68 Count	47 Count
1766027569	957 Count	68 Count	47 Count
1766026668	951 Count	68 Count	47 Count
1766025767	944 Count	66 Count	47 Count
1766024866	938 Count	65 Count	47 Count
1766023965	931 Count	65 Count	47 Count
1766023082	925 Count	65 Count	47 Count
1766022180	919 Count	65 Count	47 Count
1766021280	911 Count	64 Count	46 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)