K0FTT Automobiles

My position About ☰

reset

OK2PYA-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK2PYA-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1761868549	728 Count	47 Count	28 Count
1761868143	727 Count	47 Count	28 Count
1761866217	725 Count	47 Count	28 Count
1761864290	723 Count	47 Count	28 Count
1761862362	721 Count	47 Count	28 Count
1761860436	719 Count	47 Count	28 Count
1761858509	717 Count	47 Count	28 Count
1761856582	715 Count	47 Count	28 Count
1761854655	713 Count	47 Count	28 Count
1761852729	711 Count	47 Count	28 Count
1761850802	709 Count	47 Count	28 Count
1761848875	707 Count	47 Count	28 Count
1761846948	705 Count	47 Count	28 Count
1761846541	704 Count	47 Count	28 Count
1761844614	702 Count	47 Count	28 Count
1761842687	700 Count	47 Count	28 Count
1761840761	698 Count	47 Count	28 Count
1761838834	696 Count	47 Count	28 Count
1761836907	694 Count	47 Count	28 Count
1761834981	692 Count	47 Count	28 Count
1761833054	690 Count	47 Count	28 Count
1761831127	688 Count	47 Count	28 Count
1761829200	686 Count	47 Count	28 Count
1761824940	681 Count	47 Count	28 Count
1761823013	679 Count	47 Count	28 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)