K0FTT Automobiles

My position About ☰

reset

SP2GSM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2GSM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1762131791	869 Count	37 Count	33 Count
1762129990	868 Count	37 Count	33 Count
1762126389	866 Count	37 Count	33 Count
1762119187	862 Count	37 Count	33 Count
1762117386	861 Count	37 Count	33 Count
1762115591	856 Count	37 Count	33 Count
1762113791	855 Count	37 Count	33 Count
1762111990	854 Count	37 Count	33 Count
1762110190	853 Count	37 Count	33 Count
1762108389	852 Count	37 Count	33 Count
1762106588	849 Count	35 Count	31 Count
1762104788	846 Count	33 Count	29 Count
1762102987	844 Count	32 Count	28 Count
1762101187	842 Count	31 Count	27 Count
1762097586	839 Count	30 Count	26 Count
1762095785	838 Count	30 Count	26 Count
1762093990	833 Count	30 Count	26 Count
1762092190	832 Count	30 Count	26 Count
1762090389	831 Count	30 Count	26 Count
1762088588	830 Count	30 Count	26 Count
1762086788	829 Count	30 Count	26 Count
1762083187	827 Count	30 Count	26 Count
1762081386	826 Count	30 Count	26 Count
1762074184	817 Count	25 Count	21 Count
1762072389	811 Count	24 Count	20 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)