K0FTT Automobiles

My position About ☰

reset

SR7NSI-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR7NSI-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1761914563	345 Count	236 Count	73 Count
1761913962	344 Count	236 Count	73 Count
1761913361	343 Count	233 Count	73 Count
1761912760	342 Count	233 Count	73 Count
1761912159	341 Count	229 Count	73 Count
1761911557	340 Count	226 Count	73 Count
1761910956	339 Count	223 Count	73 Count
1761910355	338 Count	220 Count	73 Count
1761909754	337 Count	217 Count	73 Count
1761909153	336 Count	214 Count	73 Count
1761908552	335 Count	210 Count	73 Count
1761907951	334 Count	207 Count	73 Count
1761907350	333 Count	204 Count	73 Count
1761906749	332 Count	204 Count	73 Count
1761906148	331 Count	204 Count	73 Count
1761905547	330 Count	204 Count	73 Count
1761904946	329 Count	203 Count	73 Count
1761904345	328 Count	201 Count	73 Count
1761903744	327 Count	198 Count	73 Count
1761903143	326 Count	198 Count	73 Count
1761902542	325 Count	198 Count	73 Count
1761901941	324 Count	198 Count	73 Count
1761901340	323 Count	198 Count	73 Count
1761900739	322 Count	198 Count	73 Count
1761900175	321 Count	198 Count	73 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)