K0FTT Automobiles

My position About ☰

reset

UN1GWA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object UN1GWA-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1760327542	510 Count	938 Count	375 Count
1760326636	506 Count	929 Count	372 Count
1760325730	476 Count	894 Count	362 Count
1760324825	464 Count	877 Count	353 Count
1760323919	455 Count	866 Count	345 Count
1760323014	449 Count	854 Count	340 Count
1760322108	445 Count	846 Count	337 Count
1760321202	438 Count	835 Count	331 Count
1760320297	433 Count	826 Count	327 Count
1760319391	429 Count	819 Count	324 Count
1760318485	424 Count	808 Count	320 Count
1760317580	415 Count	789 Count	312 Count
1760316675	410 Count	778 Count	308 Count
1760315769	406 Count	770 Count	305 Count
1760314864	402 Count	762 Count	302 Count
1760313958	398 Count	754 Count	299 Count
1760313052	392 Count	745 Count	294 Count
1760312147	387 Count	734 Count	290 Count
1760311242	382 Count	723 Count	286 Count
1760310336	378 Count	714 Count	283 Count
1760309431	370 Count	700 Count	276 Count
1760308525	366 Count	692 Count	273 Count
1760307755	362 Count	685 Count	270 Count
1760306850	357 Count	672 Count	266 Count
1760305944	350 Count	660 Count	260 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)