K0FTT Automobiles

My position About ☰

reset

PA3GPU-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PA3GPU-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1762020466	36 Count	634 Count
1762016863	35 Count	627 Count
1762013260	34 Count	625 Count
1762009657	33 Count	623 Count
1762005474	32 Count	584 Count
1762001871	31 Count	532 Count
1761998268	30 Count	465 Count
1761994665	29 Count	434 Count
1761991062	28 Count	422 Count
1761987459	27 Count	411 Count
1761983874	26 Count	398 Count
1761980271	25 Count	386 Count
1761976668	24 Count	375 Count
1761973065	23 Count	359 Count
1761969462	22 Count	349 Count
1761965860	21 Count	346 Count
1761962273	20 Count	344 Count
1761958670	19 Count	342 Count
1761955067	18 Count	340 Count
1761951464	17 Count	331 Count
1761940673	14 Count	323 Count
1761937070	13 Count	321 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)