K0FTT Automobiles

My position About ☰

reset

SP6PGH-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6PGH-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1750113105	187 Count	580 Count	129 Count
1750111304	183 Count	566 Count	126 Count
1750109503	179 Count	554 Count	123 Count
1750107703	175 Count	542 Count	120 Count
1750105902	171 Count	531 Count	117 Count
1750104102	167 Count	519 Count	114 Count
1750080704	107 Count	315 Count	75 Count
1750078904	103 Count	302 Count	72 Count
1750077103	99 Count	287 Count	69 Count
1750075303	95 Count	278 Count	66 Count
1750073502	91 Count	265 Count	63 Count
1750071701	87 Count	253 Count	60 Count
1750069901	83 Count	239 Count	57 Count
1750068100	79 Count	227 Count	54 Count
1750066300	75 Count	214 Count	51 Count
1750064499	71 Count	202 Count	48 Count
1750062698	67 Count	189 Count	45 Count
1750060898	63 Count	176 Count	42 Count
1750059103	55 Count	164 Count	39 Count
1750057303	51 Count	154 Count	36 Count
1750055502	47 Count	139 Count	33 Count
1750053702	43 Count	125 Count	30 Count
1750051901	39 Count	112 Count	27 Count
1750050100	35 Count	98 Count	24 Count
1750048300	31 Count	84 Count	21 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)