K0FTT Automobiles

My position About ☰

reset

SR9BBC-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9BBC-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1753537526	612 Count	679 Count	254 Count
1753536625	600 Count	668 Count	243 Count
1753535724	596 Count	667 Count	242 Count
1753534823	594 Count	666 Count	241 Count
1753533922	590 Count	665 Count	240 Count
1753533020	588 Count	664 Count	239 Count
1753532119	579 Count	658 Count	233 Count
1753531218	578 Count	658 Count	233 Count
1753530317	568 Count	651 Count	226 Count
1753529417	566 Count	650 Count	225 Count
1753528516	563 Count	649 Count	224 Count
1753527615	561 Count	648 Count	223 Count
1753526714	556 Count	647 Count	222 Count
1753525813	554 Count	646 Count	221 Count
1753524912	551 Count	642 Count	220 Count
1753524011	549 Count	637 Count	219 Count
1753523110	546 Count	634 Count	218 Count
1753522209	544 Count	633 Count	217 Count
1753521308	540 Count	631 Count	215 Count
1753520408	537 Count	630 Count	214 Count
1753519507	533 Count	629 Count	213 Count
1753518700	531 Count	627 Count	212 Count
1753517799	527 Count	626 Count	211 Count
1753516898	525 Count	623 Count	210 Count
1753515997	522 Count	616 Count	209 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)