K0FTT Automobiles

My position About ☰

reset

SQ7PKP-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ7PKP-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1753539314	330 Count	240 Count	231 Count
1753538713	328 Count	239 Count	230 Count
1753538145	326 Count	238 Count	229 Count
1753537544	324 Count	237 Count	228 Count
1753536943	322 Count	236 Count	227 Count
1753536342	320 Count	235 Count	226 Count
1753535741	318 Count	234 Count	225 Count
1753535140	316 Count	233 Count	224 Count
1753534539	314 Count	232 Count	223 Count
1753533938	312 Count	231 Count	222 Count
1753533337	310 Count	230 Count	221 Count
1753532737	308 Count	229 Count	220 Count
1753532136	306 Count	228 Count	219 Count
1753531535	304 Count	227 Count	218 Count
1753530934	302 Count	226 Count	217 Count
1753530333	300 Count	225 Count	216 Count
1753529732	298 Count	224 Count	215 Count
1753529131	296 Count	223 Count	214 Count
1753528530	294 Count	222 Count	213 Count
1753527928	292 Count	221 Count	212 Count
1753527327	290 Count	220 Count	211 Count
1753526727	288 Count	219 Count	210 Count
1753526126	287 Count	219 Count	210 Count
1753525525	285 Count	218 Count	209 Count
1753524924	283 Count	217 Count	208 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)