K0FTT Automobiles

My position About ☰

reset

SP9RUT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9RUT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1750322878	277 Count	53 Count
1750321079	240 Count	47 Count
1750319278	205 Count	40 Count
1750317478	172 Count	33 Count
1750315677	137 Count	25 Count
1750313878	104 Count	18 Count
1750310272	35 Count	7 Count
1750308471	1021 Count	563 Count
1750306670	988 Count	558 Count
1750304869	952 Count	552 Count
1750299477	846 Count	528 Count
1750297673	810 Count	520 Count
1750295872	777 Count	513 Count
1750294071	741 Count	504 Count
1750292270	708 Count	498 Count
1750290471	673 Count	490 Count
1750288668	641 Count	482 Count
1750286867	605 Count	474 Count
1750283265	536 Count	461 Count
1750281464	503 Count	457 Count
1750279668	468 Count	451 Count
1750279563	462 Count	450 Count
1750279403	455 Count	448 Count
1750279241	448 Count	446 Count
1750278313	428 Count	438 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)