K0FTT Automobiles

My position About ☰

reset

SP9KKK-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9KKK-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1765989089	5 Count	385 Count
1765988188	4 Count	220 Count
1765987287	24 Count	1106 Count
1765986386	23 Count	967 Count
1765985486	20 Count	797 Count
1765984585	19 Count	781 Count
1765983683	15 Count	693 Count
1765982782	13 Count	601 Count
1765981881	10 Count	476 Count
1765980980	9 Count	373 Count
1765980080	5 Count	250 Count
1765979179	3 Count	158 Count
1765978278	0 Count	129 Count
1765977376	24 Count	1105 Count
1765976475	20 Count	955 Count
1765975574	19 Count	856 Count
1765974673	16 Count	729 Count
1765973772	14 Count	616 Count
1765972871	9 Count	529 Count
1765971970	8 Count	460 Count
1765971069	6 Count	315 Count
1765970168	5 Count	214 Count
1765969268	1 Count	115 Count
1765968365	24 Count	1008 Count
1765967465	21 Count	913 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)