K0FTT Automobiles

My position About ☰

reset

DG0MG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DG0MG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temp*	Ubat*
1749998518	27.3 degC	3.89 V
1749998216	27.3 degC	3.89 V
1749997911	27.4 degC	3.89 V
1749997609	27.4 degC	3.89 V
1749997307	27.4 degC	3.89 V
1749997005	27.5 degC	3.89 V
1749996401	27.5 degC	3.89 V
1749996099	27.5 degC	3.89 V
1749995796	27.6 degC	3.89 V
1749995492	27.6 degC	3.89 V
1749995191	27.6 degC	3.89 V
1749994586	27.5 degC	3.89 V
1749993981	27.5 degC	3.89 V
1749993377	27.3 degC	3.89 V
1749993073	27.2 degC	3.89 V
1749992771	27.2 degC	3.89 V
1749992469	27.1 degC	3.89 V
1749991260	27 degC	3.89 V
1749990958	27 degC	3.89 V
1749990652	27 degC	3.89 V
1749990351	27 degC	3.89 V
1749990296	27.3 degC	3.89 V
1749989746	27 degC	3.89 V
1749989672	27.2 degC	3.89 V
1749989444	27.1 degC	3.89 V

*Used Equation Coefficients:

Temp: 0, 0.1, -273

Ubat: 0, 0.001, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)