K0FTT Automobiles

My position About ☰

reset

IT9IJY-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IJY-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1762127650	6 Count	268 Count
1762124042	4 Count	202 Count
1762120433	2 Count	131 Count
1762116873	0 Count	31 Count
1762113264	42 Count	1000 Count
1762109656	40 Count	939 Count
1762106047	38 Count	853 Count
1762102439	36 Count	793 Count
1762098830	34 Count	735 Count
1762095271	32 Count	683 Count
1762091663	30 Count	622 Count
1762088055	28 Count	550 Count
1762084446	26 Count	393 Count
1762080838	8 Count	305 Count
1762077230	6 Count	226 Count
1762073671	4 Count	172 Count
1762070063	2 Count	103 Count
1762066454	0 Count	40 Count
1762062845	28 Count	999 Count
1762059237	26 Count	941 Count
1762055628	24 Count	876 Count
1762052071	22 Count	821 Count
1762048462	20 Count	753 Count
1762044854	18 Count	690 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)