K0FTT Automobiles

My position About ☰

reset

SQ9PL-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PL-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1763873537	284 Count	919 Count	240 Count
1763871737	276 Count	888 Count	233 Count
1763869936	268 Count	855 Count	226 Count
1763868135	257 Count	817 Count	216 Count
1763866342	247 Count	786 Count	211 Count
1763864542	238 Count	750 Count	203 Count
1763862741	232 Count	722 Count	198 Count
1763860940	222 Count	691 Count	189 Count
1763859140	213 Count	664 Count	181 Count
1763857339	204 Count	638 Count	173 Count
1763855538	195 Count	612 Count	165 Count
1763853737	189 Count	586 Count	160 Count
1763851936	182 Count	560 Count	154 Count
1763848335	168 Count	508 Count	142 Count
1763846534	163 Count	482 Count	138 Count
1763844741	150 Count	456 Count	130 Count
1763842941	142 Count	425 Count	123 Count
1763841140	134 Count	400 Count	116 Count
1763839339	127 Count	378 Count	110 Count
1763837539	120 Count	357 Count	104 Count
1763835738	113 Count	336 Count	98 Count
1763833937	106 Count	310 Count	92 Count
1763832136	98 Count	285 Count	85 Count
1763830336	89 Count	247 Count	77 Count
1763828535	81 Count	211 Count	70 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)