K0FTT Automobiles

My position About ☰

reset

4S7CRA-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 4S7CRA-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1752839855	24 Count	88 Count	5 Count
1752838951	23 Count	83 Count	5 Count
1752838047	21 Count	76 Count	4 Count
1752837143	20 Count	73 Count	4 Count
1752836239	19 Count	67 Count	4 Count
1752832716	13 Count	48 Count	2 Count
1752831812	12 Count	44 Count	2 Count
1752830908	11 Count	41 Count	2 Count
1752830004	9 Count	37 Count	1 Count
1752829099	8 Count	33 Count	1 Count
1752828195	7 Count	28 Count	1 Count
1752827291	6 Count	24 Count	1 Count
1752826388	5 Count	20 Count	1 Count
1752825484	4 Count	18 Count	1 Count
1752824579	2 Count	11 Count	0 Count
1752823675	1 Count	10 Count	0 Count
1752822771	0 Count	5 Count	0 Count
1752821868	469 Count	1004 Count	119 Count
1752820964	468 Count	1000 Count	119 Count
1752820060	467 Count	997 Count	119 Count
1752819156	465 Count	993 Count	118 Count
1752818252	464 Count	987 Count	118 Count
1752817348	463 Count	982 Count	118 Count
1752816445	462 Count	978 Count	118 Count
1752815541	461 Count	976 Count	118 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)