K0FTT Automobiles

My position About ☰

reset

VA2AIG-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VA2AIG-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1754803287	415	2000	728	4851	79
1754802497	415	2000	730	4851	78
1754800879	415	2000	736	4853	77
1754800692	416	2000	735	4853	77
1754799674	416	2000	739	4853	76
1754798887	417	2000	740	4852	76
1754797267	417	2000	744	4851	74
1754797081	417	2000	744	4851	74
1754796062	417	2000	746	4850	73
1754795281	417	2000	746	4848	74
1754794861	417	2000	747	4848	74
1754793655	417	2000	748	4847	73
1754793474	417	2000	748	4848	74
1754792452	417	2000	750	4847	73
1754791672	417	2000	751	4847	72
1754791245	417	2000	753	4847	71
1754790044	417	2000	756	4847	70
1754789871	417	2000	757	4847	70
1754788840	417	2000	759	4848	68
1754788071	418	2000	761	4849	68
1754786432	418	2000	767	4848	68
1754786266	418	2000	767	4849	68
1754785228	418	2000	773	4848	68
1754784461	418	2000	777	4848	65
1754784025	418	2000	780	4847	64

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)