K0FTT Automobiles

My position About ☰

reset

GW3ATZ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object GW3ATZ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1758627353	291 Count	662 Count	252 Count
1758623744	275 Count	630 Count	238 Count
1758620135	257 Count	597 Count	222 Count
1758616526	239 Count	559 Count	206 Count
1758612971	228 Count	527 Count	197 Count
1758609363	213 Count	488 Count	184 Count
1758605754	198 Count	452 Count	171 Count
1758602145	183 Count	417 Count	158 Count
1758598536	169 Count	377 Count	146 Count
1758594927	154 Count	336 Count	133 Count
1758591371	139 Count	298 Count	120 Count
1758587762	125 Count	265 Count	108 Count
1758584154	111 Count	229 Count	96 Count
1758580545	97 Count	200 Count	84 Count
1758576935	82 Count	173 Count	71 Count
1758573326	67 Count	147 Count	58 Count
1758569768	53 Count	124 Count	46 Count
1758566159	39 Count	99 Count	34 Count
1758562551	26 Count	70 Count	23 Count
1758558942	13 Count	39 Count	12 Count
1758555333	387 Count	1009 Count	327 Count
1758551724	375 Count	969 Count	317 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)