K0FTT Automobiles

My position About ☰

reset

SR2BC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2BC-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1742016931	11 Count	191 Count	6 Count
1742015131	9 Count	158 Count	5 Count
1742013330	7 Count	131 Count	4 Count
1742011529	5 Count	104 Count	3 Count
1742009728	3 Count	75 Count	2 Count
1742007928	2 Count	36 Count	2 Count
1742004936	26 Count	1332 Count	15 Count
1742003135	23 Count	1214 Count	13 Count
1742001334	21 Count	1075 Count	12 Count
1741999533	19 Count	963 Count	11 Count
1741997732	16 Count	829 Count	9 Count
1741995932	14 Count	706 Count	8 Count
1741994131	11 Count	578 Count	6 Count
1741992330	9 Count	467 Count	5 Count
1741990529	7 Count	342 Count	4 Count
1741988729	5 Count	227 Count	3 Count
1741986927	3 Count	129 Count	2 Count
1741985127	1 Count	30 Count	1 Count
1741982739	24 Count	1036 Count	13 Count
1741980938	22 Count	949 Count	12 Count
1741979137	20 Count	862 Count	11 Count
1741977336	18 Count	773 Count	10 Count
1741975535	15 Count	667 Count	8 Count
1741973734	13 Count	574 Count	7 Count
1741971934	11 Count	471 Count	6 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)