K0FTT Automobiles

My position About ☰

reset

LZ1PDB-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LZ1PDB-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Temperatu*	Pressure*	Battery V*
1751314727	27	952 hPa	4 V
1751314127	27	952 hPa	4 V
1751313527	28	952 hPa	4 V
1751312927	28	952 hPa	4 V
1751312327	28	952 hPa	4 V
1751311729	28	952 hPa	4 V
1751311127	28	952 hPa	4 V
1751310527	29	952 hPa	4 V
1751309927	29	951 hPa	4 V
1751309327	29	951 hPa	4 V
1751308727	29	951 hPa	4 V
1751308127	29	951 hPa	4 V
1751307527	30	951 hPa	4 V
1751306927	30	951 hPa	4 V
1751305727	30	951 hPa	4 V
1751305127	31	951 hPa	4 V
1751304527	31	951 hPa	4 V
1751303927	31	951 hPa	4 V
1751303327	31	951 hPa	4 V
1751302727	31	951 hPa	4 V
1751302127	32	951 hPa	4 V
1751301527	32	951 hPa	4 V
1751300927	32	951 hPa	4 V
1751300327	32	951 hPa	4 V
1751299727	32	951 hPa	4 V

*Used Equation Coefficients:

Temperatu: 0, 1, 0

Pressure: 0, 1, 0

Battery V: 0, 1, 0

Solar V: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)