K0FTT Automobiles

My position About ☰

reset

SP5UID-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-4. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1764269993	3 Count	451 Count
1764268192	2 Count	405 Count
1764266390	1 Count	357 Count
1764264595	0 Count	305 Count
1764262793	13 Count	1028 Count
1764260992	12 Count	976 Count
1764259191	11 Count	744 Count
1764258192	10 Count	719 Count
1764256391	9 Count	670 Count
1764254590	8 Count	636 Count
1764252793	7 Count	530 Count
1764250992	6 Count	453 Count
1764249190	5 Count	373 Count
1764247389	4 Count	308 Count
1764245594	3 Count	267 Count
1764243792	2 Count	197 Count
1764241991	1 Count	95 Count
1764240190	0 Count	40 Count
1764238393	33 Count	1022 Count
1764236591	32 Count	981 Count
1764234790	31 Count	945 Count
1764232988	30 Count	894 Count
1764231193	29 Count	846 Count
1764229392	26 Count	772 Count
1764227590	13 Count	665 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)