K0FTT Automobiles

My position About ☰

reset

OR7F-8 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OR7F-8. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*
1758215716	17	1234	3650	67
1758215237	17	1234	3651	67
1758214885	10	1232	3653	67
1758214549	10	1234	3653	67
1758214180	10	1234	3654	67
1758213861	10	1234	3654	67
1758213541	14	1234	3653	67
1758213222	10	1234	3653	66
1758212919	9	1234	3650	66
1758212599	16	1234	3648	66
1758212292	16	1234	3644	65
1758211989	16	1234	3641	65
1758211686	12	1234	3639	64
1758211383	16	1234	3635	64
1758211047	16	1234	3631	63
1758210727	15	1234	3628	63
1758210420	15	1234	3622	63
1758210039	15	1234	3617	62
1758209720	16	1234	3611	62
1758209413	16	1234	3604	62
1758209093	16	1234	3598	61
1758208774	11	1234	3591	61
1758208470	17	1229	3584	60
1758208167	16	1229	3578	60
1758207860	16	1225	3575	58

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)