K0FTT Automobiles

My position About ☰

reset

MB7ULR Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MB7ULR. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1768173274	417 Count	101 Count	66 Count
1768169673	414 Count	98 Count	64 Count
1768166072	411 Count	95 Count	62 Count
1768162471	408 Count	92 Count	60 Count
1768158870	405 Count	89 Count	58 Count
1768155269	402 Count	86 Count	56 Count
1768151668	399 Count	83 Count	54 Count
1768148068	396 Count	80 Count	52 Count
1768144467	393 Count	77 Count	50 Count
1768140866	390 Count	74 Count	48 Count
1768137265	387 Count	71 Count	46 Count
1768133664	384 Count	68 Count	44 Count
1768130063	381 Count	65 Count	42 Count
1768126463	378 Count	62 Count	40 Count
1768122862	375 Count	58 Count	38 Count
1768119261	372 Count	55 Count	36 Count
1768115660	369 Count	52 Count	34 Count
1768112059	366 Count	49 Count	32 Count
1768108458	363 Count	46 Count	30 Count
1768104857	360 Count	43 Count	28 Count
1768101256	357 Count	40 Count	26 Count
1768097655	354 Count	37 Count	24 Count
1768094054	351 Count	34 Count	22 Count
1768090454	348 Count	31 Count	20 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)