K0FTT Automobiles

My position About ☰

reset

SP1KRF-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP1KRF-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1746668130	117 Count	188 Count	48 Count
1746666928	114 Count	184 Count	47 Count
1746665727	111 Count	179 Count	46 Count
1746664525	107 Count	173 Count	44 Count
1746663324	104 Count	168 Count	43 Count
1746662150	101 Count	163 Count	42 Count
1746660948	97 Count	157 Count	40 Count
1746659747	94 Count	152 Count	39 Count
1746658545	91 Count	147 Count	38 Count
1746657344	87 Count	141 Count	36 Count
1746656142	84 Count	136 Count	35 Count
1746654941	81 Count	131 Count	34 Count
1746653739	76 Count	124 Count	31 Count
1746652538	73 Count	119 Count	30 Count
1746651336	69 Count	113 Count	28 Count
1746650136	64 Count	106 Count	25 Count
1746648933	61 Count	101 Count	24 Count
1746647732	58 Count	96 Count	23 Count
1746646530	54 Count	90 Count	21 Count
1746645329	51 Count	85 Count	20 Count
1746644127	48 Count	80 Count	19 Count
1746642926	44 Count	74 Count	17 Count
1746641724	41 Count	70 Count	16 Count
1746640570	38 Count	65 Count	15 Count
1746639368	34 Count	59 Count	13 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)