K0FTT Automobiles

My position About ☰

reset

SR9EMP-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9EMP-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1768181614	1 Count	236 Count
1768179813	0 Count	0 Count
1768178041	3 Count	820 Count
1768176240	2 Count	602 Count
1768174440	1 Count	407 Count
1768172618	0 Count	219 Count
1768170818	7 Count	1084 Count
1768169017	5 Count	875 Count
1768167216	4 Count	652 Count
1768165415	2 Count	449 Count
1768163614	1 Count	244 Count
1768161814	5 Count	1077 Count
1768160013	4 Count	713 Count
1768158212	3 Count	488 Count
1768156420	1 Count	253 Count
1768154619	11 Count	1156 Count
1768152818	5 Count	885 Count
1768151017	4 Count	665 Count
1768149216	2 Count	415 Count
1768147416	1 Count	197 Count
1768145615	16 Count	1086 Count
1768143814	6 Count	892 Count
1768142013	5 Count	675 Count
1768140213	3 Count	425 Count
1768138412	2 Count	215 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)