K0FTT Automobiles

My position About ☰

reset

F4GMT-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4GMT-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1770073638	105 Count	244 Count
1770072738	104 Count	242 Count
1770071837	103 Count	238 Count
1770070936	102 Count	236 Count
1770070053	97 Count	233 Count
1770069152	96 Count	231 Count
1770068251	95 Count	227 Count
1770067350	94 Count	225 Count
1770066450	93 Count	222 Count
1770065549	92 Count	220 Count
1770064648	91 Count	215 Count
1770063747	90 Count	213 Count
1770062846	89 Count	210 Count
1770061946	88 Count	208 Count
1770061045	87 Count	203 Count
1770060144	86 Count	201 Count
1770059243	85 Count	198 Count
1770058342	84 Count	196 Count
1770057442	83 Count	192 Count
1770056541	82 Count	190 Count
1770055640	81 Count	187 Count
1770054739	80 Count	185 Count
1770053839	79 Count	181 Count
1770052938	78 Count	179 Count
1770052037	77 Count	176 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)