K0FTT Automobiles

My position About ☰

reset

SP5JWP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5JWP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1753294569	270 Count	991 Count	234 Count
1753292768	249 Count	908 Count	214 Count
1753290968	223 Count	758 Count	190 Count
1753289167	198 Count	666 Count	167 Count
1753287366	173 Count	570 Count	144 Count
1753285566	147 Count	491 Count	120 Count
1753283765	124 Count	409 Count	98 Count
1753281964	91 Count	319 Count	68 Count
1753280163	78 Count	271 Count	56 Count
1753278363	66 Count	229 Count	47 Count
1753276572	43 Count	177 Count	34 Count
1753256763	319 Count	799 Count	259 Count
1753253168	301 Count	752 Count	249 Count
1753251367	295 Count	732 Count	244 Count
1753249566	289 Count	715 Count	240 Count
1753247766	281 Count	690 Count	234 Count
1753245965	275 Count	670 Count	229 Count
1753244164	266 Count	648 Count	223 Count
1753242364	259 Count	616 Count	217 Count
1753240563	250 Count	595 Count	211 Count
1753238762	242 Count	571 Count	205 Count
1753236961	234 Count	551 Count	199 Count
1753235160	226 Count	531 Count	194 Count
1753233367	215 Count	508 Count	188 Count
1753231566	207 Count	485 Count	182 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)