K0FTT Automobiles

My position About ☰

reset

CT2IKC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object CT2IKC-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1753543311	111 Count	182 Count	88 Count
1753541507	108 Count	165 Count	86 Count
1753539704	105 Count	160 Count	84 Count
1753537900	100 Count	154 Count	80 Count
1753536096	95 Count	146 Count	76 Count
1753534293	91 Count	138 Count	73 Count
1753532489	86 Count	131 Count	69 Count
1753530685	83 Count	126 Count	67 Count
1753528882	80 Count	121 Count	65 Count
1753527078	77 Count	116 Count	63 Count
1753488782	76 Count	116 Count	63 Count
1753486978	71 Count	109 Count	59 Count
1753485216	66 Count	102 Count	55 Count
1753483412	61 Count	95 Count	51 Count
1753481608	56 Count	88 Count	47 Count
1753479805	51 Count	82 Count	43 Count
1753478001	46 Count	73 Count	39 Count
1753476198	41 Count	64 Count	35 Count
1753474394	36 Count	57 Count	31 Count
1753472591	31 Count	49 Count	27 Count
1753470787	26 Count	41 Count	23 Count
1753468984	21 Count	35 Count	19 Count
1753467180	16 Count	28 Count	15 Count
1753465377	6 Count	11 Count	6 Count
1753463615	580 Count	1027 Count	493 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)