K0FTT Automobiles

My position About ☰

reset

SQ3MQD-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ3MQD-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1761919078	564 Count	55 Count
1761918177	563 Count	55 Count
1761917293	562 Count	55 Count
1761916392	561 Count	55 Count
1761915492	560 Count	55 Count
1761914591	559 Count	55 Count
1761913690	558 Count	55 Count
1761912790	557 Count	55 Count
1761911889	556 Count	55 Count
1761910988	555 Count	55 Count
1761910087	554 Count	55 Count
1761909187	553 Count	55 Count
1761908286	552 Count	55 Count
1761907385	551 Count	55 Count
1761906485	550 Count	55 Count
1761905584	549 Count	55 Count
1761904683	548 Count	55 Count
1761903782	547 Count	55 Count
1761902882	546 Count	55 Count
1761901981	544 Count	55 Count
1761901080	543 Count	55 Count
1761900180	542 Count	55 Count
1761899279	541 Count	53 Count
1761898378	540 Count	50 Count
1761897477	539 Count	45 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)